Kryolan
Products for Alteration of Facial Contours


Wax Compositions for three dimensional effects
A 3-D alteration of the shape of the nose may be achieved with the materials described as follows. When working with these materials the fingers should be dipped in a gel, or water if gel is not available to prevent the wax material from adhering to the fingers. 3-D wax preparations should be applied and sealed, using KRYOLAN Sealer before the foundation. After the performance the artificial (sculpted) nose may be removed by holding a thread between two fingers and sliding the thread down the bridge towards the tip of the nose to loosen the wax material, the residue of which may then be removed with Make-up Remover.


Nose Putty
Wax stick composition for moulding noses. Manipulate in hand until mouldable. Recommended using gel on fingers to prevent putty from sticking to fingers. May be adhered to skin with Spirit Gum.

CAT # Description Price
K01400 0.5 oz stick $4.70 Add

Soft Putty
Soft nose putty, suitable for general moulding use. May be adhered to skin with Spirit Gum.

CAT # Description Price
K01430 3.3 oz $11.00 Add
K01431 1.75 oz $7.80 Add

Plastici, Nose and Scar Wax

CAT # Description Price
K01411 2 oz $9.90 Add

Plastici Stick
A tinted soft wax stick for modeling noses, chins, or facial contours on bony surfaces.

CAT # Description Price
K01410 0.5 oz stick $4.70 Add

Eyebrow Plastic
Flesh-colored wax stick for blocking out eyebrows. Wax stick may be first applied on brow in stroking motions from nose bridge out to end of brow. Reverse motion, "against the growth" of brow then repeat first motions "with the growth" of the brow to smooth wax in place. When brow is covered with wax, cover wax with 1 or 2 coats of sealor (K01481/K01480, listed below). As an alternative Eyebrow Cover, you may use Water Soluble Spirit Gum (K06000, K06001, K06002, listed below).

CAT # Description Price
K01420 0.5 oz stick $6.00 Add

Water-Soluble Spirit Gum

CAT # Description Price
K06000 0.06 fl oz, Glass Vial $1.00 Add
K06001 0.5 fl oz, with Brush $3.90 Add
K06002 1.76 fl oz, in non-stick cap w/brush $8.20 Add

Special Plastic
A high quality micro-crystalline wax. Ideal for creating scars and changing contours. Excellent for blocking out very bushy eyebrows. Should be coated with Sealor K01481. Flat round container with 1.3 oz.

CAT # Description Price
K05412 1.3 oz $10.00 Add

Natural Plastic (Dodge Modeling Wax)

An extensive search for a formula close to the original has been found! This product has firmness for the successful creation of your desired effects.

CAT # Description Price
K01440 12 oz $19.90 Add

Sealor Flexible
A quick-drying liquid for sealing wax surfaces and prosthetics before applying makeup. Soluble and removable with alcohol. Replaces flexible collodion.

CAT # Description Price
K01480 4 oz $10.10 Add
K01481 1 oz $5.30 Add

Products for alteration of skin structure


FX Wax
Works great for recreating scars, warts, and other special effects. Apply with wet fingers. To remove, use a spatula and scrape off with soap and warm water. .

CAT # Description Price
K01415 0.5 oz $2.00 Add
K01416 5 oz $19.00 Add

Stoppelpaste, Stipple Wax
Stipple wax in propelling stick container. Adhering wax material for stipple hair to simulate an unshaven look. Also suitable to stick glitters. May be washed off with soap and water.

CAT # Description Price
K01460 1 oz $8.70 Add

Rigid Collodion, for scar effects
The traditional scar effect material which shrinks the skin to simulate an intended cut. Warning: contains ether. Repeated use in the same area can irritate the skin.

CAT # Description Price
K01470 1 fl oz $4.60 Add

Tuplast
Plastic in tube form used to create small flexible cuts, abrasions, etc. Can be sculpted on glass or prepared in a plaster mould which has been sealed with shellac or varnish and lightly coated with petroleum jelly. Deep moulds require several layers. When cured can be glued to the skin. Residues may be removed with OLD SKIN PLAST Remover K02037.

CAT # Description Price
K02599 0.5 oz Tube, Available in Clear or Flesh Currently Unavailable

Old Skin Plast, Remover

CAT # Description Price
K02037 4 fl oz $7.00 Add

Old Skin Plast, Matt
Special product for creation of wrinkled skin. Apply with 1 1/2" natural bristle brush. Use in well ventilated areas or with fan.
Advantages over latex method: 1) Speedy application, 2) doesn't require a hair dryer because it dries rapidly. For slower application may be thinned with Acetone. To remove use OLD SKIN PLAST Remover K02037 (listed above). This product is designed for professional use only. Should not be used on hypersensitive skin.

CAT # Description Price
K06591 3.3 fl oz, bottle $20.00 Add

Old Age Stipple
Liquid latex stipple used to create aged skin effects and for blending prosthetics. Apply with a foam rubber sponge while skin is stretched, dry with a hair dryer on low heat and powder before skin is relaxed. Most naturalistic effect for film, TV, and photo.

CAT # Description Price
K06570 3 fl oz $6.00 Add

Gel Fix Skin Pack
Ready prepared gelatin based product. Heat in water bath and apply to desired area. Check temperature prior to application. May be removed with soap and warm water. Bag with 2 oz.

Select: clear, red, flesh.

CAT # Description Price
K06545 2 oz $6.00 Add

Download the 19 page Kryolan Product List in PDF format Right Now!
Go to Kryolan Product List on Web Right Now!


This page originally posted: 02/10/2005
This page last updated: 02/24/2010